Technical Specifications
General Specifications
- 750-lb. capacity
- Speed: 10 FPM with a 1 HP, 115-volt motor
- Lifting Height: up to 168 inches
- Two-year limited parts warranty on the basic unit, including all electrical and drive components
- Constructed of 12-gauge minimum hot rolled steel. If unit is not installed in a 3-inch pit, an auto-retracting ramp shall be provided that extends to meet lower landing.
- Carriage platform supports -½” steel plate and carriage uprights shall be a minimum of 3/8” thick laser cut steel plate.
- Platform side panel - 42 inches high. Side panel framework - 1” x 1 ½” steel. Solid infill panels – 18-gauge steel
- Flush mounted, 42” high, steel gate and frame for upper landing.
- Gate includes spring hinges, outer gate handle and mechanical-electrical interlock assembly.
- Flush mounted, 80” high, steel gate and frame for upper landing.
- Gate includes spring hinges, outer gate handle and mechanical-electrical interlock assembly.
- Flush mounted, 42” high, solid core oak laminated gate and oak frame for upper landing. Gate includes spring hinges, dead latch, dummy trim gate handle, lock plate cover and electric strike.
- CWD flush mounted, solid core oak laminated door and oak frame. Door includes mesh vision panel with delay action door closure, dead latch, dummy trim door handle, lock plate cover and electric strike.
- CSD-Non-Rated (NR) low profile flush mounted steel door and frame. Door includes mesh vision panel with delay action door closure, dead latch, dummy trim door handle, lock plate cover and electric strike.
- Optional platform configuration; 90 degree; other platforms are available 36” x 54”, 36” x 48”, 36” x 60” and 42” x 60”.
Mechanical Equipment
- 1 HP, 115 volt (optional 230 volt), 1 phase motor
- Operating control circuit - regulated N.R.T.L. listed class 2 power limited circuit operating at 24vdc.
- The drive mechanism - stationary nut on a rotating 1” diameter Acme screw with a secondary safety nut.
Safety Devices
- Nonskid platform surface
- Obstruction safety panel under platform (when not installed with a runway enclosure)
- Alarm and emergency stop switch
- Grab rail
- Landing interlocks keep door locked when the lift is on another floor
- Upper final limit
- A gate with a min. height of 42 inches and a combination mechanical lock with an electric contact is provided at the upper landing.
- A gate with a combination mechanical lock with an electric contact is provided at the platform or lower level as required.
- Loaded fasteners—grade eight or higher. Locking fasteners used in all critical locations.
- CSD-Rated (R) fire rated (B Label) flush mounted steel door and frame. Door includes wire mesh vision panel with delay action door closure, dead latch, dummy trim door handle and electric strike.
- Optional manual lowering device
- 24-volt DC, fail secure electric strike that contains electric contacts to insure the door is both closed and locked
Controls
- Remote mounted controller allows for readily serviceable diagnostics at upper or lower landing
- Mid-mount gate operator
- Low-power door operator: 115-volt, 15-amp, low-energy. ADA-compliant processor controlled and fully adjustable operator
